HID Installation

1

Connect the HID

• wire the HID to both PCs following the setup instructions per the manufacturer

2

Identify the connection method

For NET devices:

• KM BOX NET and other devices supporting the NET protocol connect to the DMA cheat software via network connection
• note the IP address, port, and UUID of the NET connection you are using with your NET based device
• configure the DMA cheat with this information

For B+ devices:

• B+ or B PRO devices connect via serial connection; so long as the device is connected and seen by the PC, it will natively connect
• Check your DMA cheat; it should have an option to select KM BOX B+/PRO in the aim device/HID settings

For MAKCU and Ferrum One devices

• both of these HIDs are natively supported in essentially all DMA cheats on the market
• the Ferrum One supports connecting via any connection protocol (serial, NET, etc.) and so even if the DMA cheat does not specifically state it supports the Ferrum - it does. Connect using B+/Pro if your cheat does not list the Ferrum as an option for best results.