RDMA ✕ DEXAIMDMA

RDMA - DMA without DMA hardware or firmware. Cost-effective entry into DMA products. Works with up to VGK AC.

Shop RDMA

DEXAiM RDMA | No-USB Network Memory Access | dexaimdma.comDEXAIM DMA

Requirements

• two (2) CAT6A ethernet cables (or better)
• network card installed in the GAMING PC using the Realtek RTL8125 or RTL8126 chipset

  • alternatively, if the motherboard has an onboard Realtek RTL8125 or RTL8126 chipset, this will work - no need to buy a separate network card
• a second PC (to run the DMA product you wish to use)

Hardware Setup

1

Install the network card (NIC) into the GAMING PC

• using any open PCIe slot, install the NIC

2

Connect the ethernet cabling

• Connect one ethernet cable from the GAMING PC to the router
• Connect the second ethernet cable to the DMA PC and router

Cabling layout for RDMA setup.

On the GAMING PC

1

Initial setup

• Press the Windows key → type cmd → type systemctl reboot --firmware-setup
• The PC should reboot. Enter BIOS when prompted. Disable secure boot. Save changes, reboot the PC
• Press the Windows key → type cmd → type bcdedit /set testsigning on, reboot the PC
• Press the Windows key → type Device Manager → Enter → Network adapters → select the 8125 network card you are using (or 8126) → Driver → Update driver → Browse, then select the folder containing 8125.inf or 8126.inf
• Press the Windows key → type cmd → type bcdedit /set testsigning off
• Reboot the PC
• Run MacAddressRetrieval.exe
• Send the generated leechcore.ini file to the DMA PC

On the DMA PC

1

Initial setup

• Replace leechcore.dll in the software you intend to use.

Every DMA cheat product includes a leechcore.dll either with the loader download, or is generated by the loader when ran for the first time. Check the folder where the loader is located to find leechcore.dll.

• Place leechcore.ini in the same directory as leechcore.dll.
• Enter your key from your order.